<dd id="ytclb"></dd>
    1. <progress id="ytclb"></progress>

        <dd id="ytclb"></dd>

          Sinumerik SLOT1 Slots on a circle

          Sinumerik SLOT1 Slots on a circle

          With Sinumerik SLOT1 cycle, slots can be produced arranged on a circle. The longitudinal axis of the slots has a radial orientation In contrast to the elongated hole, a value is specified for the slot width.
          Sinumerik SLOT1 cycle is a combined roughing/finishing cycle.

          Programming

          SLOT1 (RTP, RFP, SDIS, DP, DPR, NUM, LENG, WID,
                CPA, CPO, RAD, STA1, INDA, FFD, FFP1, MID, CDIR,
                FAL, VARI, MIDF, FFP2, SSF)

          Sinumerik SLOT1 Slots on a circle

          Parameters

          ParameterDescription
          RTPReturn plane (absolute)
          RFPReference plane (absolute)
          SDISSafety distance (enter without sign)
          DPFinal drilling depth/elongated hole depth/slot depth/pocket depth (absolute)
          DPRFinal drilling depth/elongated hole depth/slot depth/pocket depth relative to reference plane (enter without sign)
          NUMNumber of holes/elongated holes/slots
          LENGLength of elongated hole/slot length/pocket length (without sign)
          WIDSlot width/pocket width (enter without sign)
          CPACenter point circle/pocket, abscissa (absolute)
          CPOCenter point circle/pocket, ordinate (absolute)
          RADRadius of circle (enter without sign)
          STA1Starting angle, values: -180 to 180 degrees
          INDAIndexing angle
          FFDFeedrate for depth infeed
          FFP1Feedrate for surface machining
          MIDMaximum insertion depth for insertion (enter without sign)
          CDIRDirection of machining Values:
          2 (for G2)
          3 (for G3)
          FALCorrect finishing allowance for contour (enter without sign)
          VARIMachining mode
          0=complete machining
          1=solid machining to finishing allowance
          2=only machining of finishing allowance
          MIDFMaximum insertion depth for final allowance
          FFP2Feedrate for final allowance
          SSFSpeed during finishing
          手机赢三张